Craftsman 4 Gallon Twin Tank Compressor Manuel du propriétaire télécharger pdf (Page 12)

GENERALMAINTENANCE

When servicing, use only identical

replacement parts. Use of any other parts may create a

hazard or cause product damage.

Always wear safety goggles or safety

glasses with side shields during power tool operation or when

blowing dust. If operation is dusty, also wear a dust mask.

Always release all pressure, disconnect

from power supply, and allow unit to cool to the touch before

cleaning or making repairs on the air compressor.

Humidity in the air causes condensation to form in the air tank.

This condensation should be drained daily and/or every hour,

using the instructions found in DrainingtheTank.

The safety valve automatically releases air if the air receiver

pressure exceeds the preset maximum. Check the safety valve

before each use following the instructions found in Checking the

SafetyValve.

Inspect the tank yearly for rust, pin holes, or other imperfections

that could cause it to become unsafe.

Avoid using solvents when cleaning plastic parts. Most plastics

are susceptible to damage from various types of commercial

solvents and may be damaged by their use. Use clean cloths to

remove dirt, dust, oil, grease, etc.

WARNING

Do not at any time let brake uids, gasoline,

petroleum-based products, penetrating oils, etc., come in

contact with plastic parts. Chemical can damage, weaken

or destroy plastic which may result in serious personal

injury. Electric tools used on berglass material, wall-board,

spackling compounds, or plaster are subject to accelerated

wear and possible premature failure because the berglass

chips and grindings are highly abrasive to bearings, brushes,

commutators, etc. Consequently, we do not recommend

using this tool for extended work on these type of materials.

However, if you do work with any of these materials, it is

extremely important to clean the tool using compressed air.

LUBRICATION

All the bearings in this tool are lubricated with a sufcient amount

of high grade lubricant for the life of the unit under normal

operating conditions. Therefore, no further lubrication of the

bearings is required.

WARNING

MAINTENANCE

Maintenance schedule

Items to check/change

Before

use

Daily

Every

hour

Checking the safety valve ●

Overall unit visual check ●

Draining the tank ● ●

Check power cord for damage ●

STORAGE

ENDOFOPERATION/STORAGE

Turn the ON/OFF switch to the OFF(O) position.

Unplug power cord from wall outlet and wrap it to prevent

damage when not in use.

Wearing safety glasses drain tank of air by pulling the ring

on the safety valve. Use other hand to deect fast moving air

from being directed toward your face.

Drain tank of condensation by opening drain valve on bottom

of tank. Tank pressure should be below 10 psi when draining

tank.

Air hose should be disconnected from compressor and hung

open ends down to allow any moisture to drain.

Compressor and hose should be stored in a cool, dry place.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Craftsman 4 Gallon Twin Tank Compressor Manuel du propriétaire Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Compresseurs d'air Craftsman 4 Gallon Twin Tank Compressor