Craftsman 28180 - Fixed-Base Router/Table Combo Manuel télécharger pdf (Page 26)

,_ WARNING: Always remove cutting bits from the collet/nut when the router is

not being used. Leaving bits installed could result in an accident causing serious

personal injury.

Three Mounting Positions For Auxiliary Handle Of D-Handle Base (Fig. 12)

There are three mounting

positions on D-handle base

for auxiliary handle (Fig. 12);

you can choose the desired

position to install the auxiliary

handle for ease of operation.

1. Turn the auxiliary handle

counterclockwise to loosen

it and remove the auxiliary

handle from the base.

Align the screw on the

auxiliary handle with the

desired mounting hole

located on the left side of

the D-handle base.

3. Turn the auxiliary handle clockwise until it is firmly tightened.

ADJUSTING DEPTH OF CUT

WARNING: Your router should never be turned on or connected to the

power source when you are assembling parts, making adjustments, installing

or removing collets/nuts or cutting bits, cleaning, or when it is not in use.

Disconnecting the router will prevent accidental starting, which could cause

serious personal injury.

NOTE: All depth adjustments on the Fixed Base or D-Handle Base must be

made with the router motor clamp open.

NOTE: For the Fixed Base or D-Handle Base, the cutting bit depth equals the

amount of the cutter that is exposed below the surface of the sub-base.

28084 Manual Revised 07-0712 Page 26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 67 68

Pas de commentaire

Craftsman 28180 - Fixed-Base Router/Table Combo Manuel Page 26