Craftsman 113.198310 Manuel du propriétaire télécharger pdf (Page 31)

OPERATION NO. 5 -

OUT-RIPPING AND IN-RIPPING

1. Ripping is the process of sawing the workpiece

along its length by feeding it into the sawblade

when using the fence as a guide and as a

positioning device to obtain the desired width of

cut. The sawblade is parallel to fence.

2. Since the work is pushed along the fence, it must

have a straight edge in order to make sliding

contact with the fence. Also, the work must make

solid contact with the table, so that it will not

wobble or kickback. Provide a straight edge, to

avoid kickback or binding, even if it means

temporarily nailing an auxiliary straight edge

board to the workpiece being ripped.

WARNING: IF THE WORKPIECE IS WARPED, DO

NOT ATTEMPT TO MAKE A CUT IF THE WORK-

PIECE WOBBLES OR ROTATES ON THE TABLE.

IT COULD BIND AND KICKBACK.

3. Always use the saw guard and make sure the

spreader is correctly aligned with the kerf and

the anti-kickback pawls are properly adjusted.

Wood cut with the grain tends to spring the kerf

closed and bind the blade and cause a kickback

or slip of your hand. Always adjust the spreader

to ride in the kerf and prevent the kerf from

closing.

4. Stand a little to one side of the blade to be clear of

workpiece in case of kickback.

5. Always push the workpiece past the blade so it is

clear of the blade. This procedure will help avoid

kickbacks. DO NOT TOUCH the cutoff piece

until the power is off and the blade has stopped

spinning.

IN-RIPPING

The radial arm and bevel are indexed at 0° and

locked, but the yoke is turned 90 degrees in a

clockwise direction (viewed from above) from the

crosscut position. Thus, when standing in front of

the saw, the blade would be rotating counterclock-

wise. After positioning the guard and anti-kickback

mechanism the workpiece is fed from the right-hand

side of the saw.

OUT-RIPPING

The radial arm and bevel are indexed at 0° and

locked, but the yoke is turned 90 degrees in a

counterclockwise direction (viewed from above),

from the crosscut position. When standing in front of

the saw, blade would be rotating clockwise. After

positioning the guard and anti-kickback mechanism

the workpiece is fed from the left-hand side of the

saw

OUT-RIPPING

IN-RIPPING

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Craftsman 113.198310 Manuel du propriétaire Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Diffuseur Craftsman 113.198310