Craftsman 113.198310 Manuel du propriétaire télécharger pdf (Page 29)

rectangularframe.Theradialarmissettoadesired

angleof cut, swiveland bevelsettingsat 0° and

locked.Theworkpiecebeingcutispositionedand

heldfirmlyagainstthefenceandthecarriagepulled

forwardalong the radial armjust far enoughto

completethecut.Carriageshouldthenbereturned

to the full rearpositionandlocked.Allowthesaw

bladeto cometo astopbeforeremovingthework-

piecefromthesawtable.

OPERATION NO. 3 - BEVEL CROSSCUT

Bevel crosscutting is the process of sawing at 90 °

(square) across the width of a workpiece with the

saw blade set to an angle other than 90 ° to the table.

The radial arm and yoke are indexed at 0° and

locked securely in place. The bevel is set to the

desired angle of cut and locked. The workpiece

being cut is positioned and held firmly against the

fence and the carriage is pulled forward along the

radial arm just far enough to complete the cut. The

carriage should then be returned to the full rear

position and locked. Allow the saw blade to come to

a stop before removing the workpieces from the saw

table.

OPERATION NO. 4 -

COMPOUND CROSSCUT

Compound crosscut is the combination of miter and

bevel crosscut. The radial arm and the angle of the

blade are set to produce the desired cut - the yoke is

indexed at 0° and locked. The workpiece is posi-

tioned and held firmly against the fence and the

carriage is pulled forward along the radial arm just

far enough to complete the cut. The carriage should

then be returned to the full rear position and locked.

Allow the blade to come to a stop before removing

the workpieces from the saw table.

REQUIREMENT WHEN RIPPING

(Operations 5 and 6)

WARNING: TO AVOID MISTAKES THAT COULD

CAUSE SERIOUS PERMANENT INJURY, OBSERVE

ALL THE FOLLOWING INSTRUCTIONS IN ADDI-

TION TO THOSE ON PAGES 2-6.

1. Make sure that the blade is sharp, correctly set

and undamaged.

2. Lock the rip lock handle. (See page 24).

3. Lock the radial arm at the 0 ° position.

4. Make sure the workpiece is kept in firm contact

with the fence and the table. The edge of the

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Craftsman 113.198310 Manuel du propriétaire Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Diffuseur Craftsman 113.198310