Craftsman 113.198310 Manuel du propriétaire télécharger pdf (Page 15)

4. Position the trim caps in place and hold in place

with type B metal screw from the bottom side.

5. Then reach through the base from behind the

front table board and secure the trim cap with

two (2) type "BT" screws using a phillips screw-

driver. Repeat procedure for other side.

TRIM CAF

ATTACH ELEVATION HANDWHEEL

1. From loose parts bag #497, find one (1) screw

10-32 x 1/2 and one (1) external Iockwasher.

Install handwheel to front of base as illustrated.

ELEVATION

HANDWHEEL

MOUNTING MOTOR

1. Remove the blade guard. Locate the arbor

wrenches and remove the blade.

CAUTION: Do not attempt to mount the motor until

the blade guard and blade have been removed.

2. Elevate the arm approximately 2 inches to remove

shipping pad.

3. Using a 3/4 socket remove 1/2-13 lock nut and

1/2" flat washer from motor pivot support.

4. Slide motor on motor pivot support until motor is

firmly seated on support as illustrated.

5. Re-install the flat washer and lock nut and

tighten until snug with 3/4" socket.

WARNING: DO NOT OVER TIGHTEN LOCKNUT.

To insure proper function of the bevel lock, move the

bevel lock handle while tightening the Iocknut.

Adjust according to Step 6.

6. Push bevel lock handle to left side to lock.

NOTE: Bevel lock handle should not contact extreme

left side of yoke when in locked position. If bevel

lock handle is permitted to contact yoke the following

adjustment is required

a. Unlock bevel lock handle and tighten motor

Iocknut. Recheck bevel lock handle position (see

illustration).

b. Repeat adjustment if necessary Do not over

tighten or motor will not index.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Pas de commentaire

Craftsman 113.198310 Manuel du propriétaire Page 15