Craftsman NEXTEC 320.30565 Manuel de l'opérateur

Operator's ManualnEXTEC12.0-Volt LITHIUM-ION MULTI-SAWModel No. 320. 10004©Powered by anENERGYSTAR®qualified batterycharger for aIlmll:i_'dk

REMOVING SAWBLADE (Fig. 7)1. Remove the battery pack.2. Lift up the lever of the tool-less clamp, to removethe blade.NOTE: Allow blade to cool afterus

,_ WARNING: Always clamp and support workpiece securely. Always maintainproper control of saw. Failure to clamp and support workpiece and loss ofcontr

/ d-"{ol!J_].l_']_'[oIoJmllI_[e_PROBLEM CAUSE SOLUTIONThe trigger can not be The "lock-off" button Depress the "lock-off

12.0 VOLT LITHIUM-ION CORDLESS Multi-Saw MODEL NUMBER 320.10004The Model Number will be found on the Nameplate attached to the handle of theMulti-Saw.

10004 Manual_Revised_08-08!3 Page 26 10004 ManuaLRevised_08-0813 Page 27

Your HomeFor expert troubleshooting and home Solutions advice:manage hi ewww.managemyhome.c_I I!l!lFor repair - in your home - of all maj_ brand appli

bL'_:]_ _o__o_Warranty Page 2Safety Symbols Pages 3-4Safety Instructions Pages 5-11Description Pages 11-12Assembly Page 13Operation Pages 14-20Ma

Some of the following symbols may be used on this tool. Please study themand learn their meaning. Proper interpretation of these symbols will allow yo

• The Multi-Saw worklight may produce sufficient heat to melt somefabrics. To avoid serious personal injury, keep the Multi-Saw worklight freeof conta

POWER TOOL USE AND CAREDo not force the power tool. Use the correct power tool for yourapplication. The correct power tool will do the job better and

• If liquid from the battery gets in your eyes, flush them with clean water forat least 10 minutes, and then seek immediate medical attention. Followi

PRODUCT SPECIFICATIONSMotor Voltage 12V DCNo load speed 2000SPMLength of stroke 16mmBlade type !T and U shankSaw weight (without battery) 1.llbsBatter

[o)_j_[o)_LOW-BATTERY CAPACITY INDICATORIf the LED worklight begins to rapidly and continuously flash when the triggerswitch on the saw is depressed,

TRIGGER SWITCH (Fig. 4)To turn the saw ON, depressthe lock-off button and thendepress the trigger switch.To turn it OFF, release thetrigger switch and