Owner's Manual1/3-SheetPad SanderModel No.172.11625CAUTION: Read, understand and followall Safety Rules and Operating Instructionsin this manual
Electrical ConnectionYour sander has a precision-buiR electric motor and it should only beconnected to a 120-volt, 60-Hz. power supply (normal househo
Installing Non-Adhesive Sandpaper cont. (see Fig.2)2. Remove dust bag assembly,3. If replacing sandpaper, remove old sandpaper.4. To remove old sandpa
Installing Adhesive-Backed Sandpaper cont. (See Fig. 3)4, Place levers back in locked position (see Steps 6 and 8 on InstallingNon-Adhesive Sandpaper)
ATTACHING DUST BAG ASSEMBLY cont. (See Fig. 4)2. Insert dust bag adapter into dust exhaust hole (see Fig. 4).3. Push in adapter until the raised edges
ATTACHING THE VACUUM HOSE ADAPTER (See Fig, 6)Your sander includes a vacuum hose adapter that easily attaches to thesander. The adapter allows you to
Z_ WARNING: ALWAYS wear safety gogglesor safety glasses with side shield and a full faceshield when operating your sander. Failure to do socould resul
SANDING TIPS1. DO NOT force the sander. The weight of the sander supplies adequatepressure. Let the sander and the sandpaper do the work.A. Applying a
ORBITAL MOTION (See Fig. 8)As shown in Figure 8, the orbit of the sander is 1/16-inch in diameter so thesandpaper moves in tiny circles at high speed.
REMOVE PRESSURE-SENSITIVE SANDPAPER BEFORE STORAGEDO NOT store your sander with pressure-sensitive sandpaper still attached.The heat generated by sand
EXTENSION CORDSThe use of any extension cord will cause some loss of power. To keep theloss at a minimum and to prevent overheating, use an extension
Warranty. ... Page 2Safety Instructions ... Pages 3-8Safety Symbols
1/3 PAD SANDER- MODEL NUMBER 172.11625The Model Number will be found on the Nameplate.Always mention the Model Number when calling about your tool.No.
2213141921
+:,:+:*:*:H+::+:.:,:i,_i_!ii'i"iiii!i!i!i!iiiii_i,_,... %iiiiiii i!i iliiiiiiiiii!i!i!ii Your HomeFor repair in your home of all major
I Z_ WARNING: BE SURE to read and understand all instructions, IFailure to follow all instructions listed below may result in electricIshock, fire and
ELECTRICAL SAFETY cont.NOTE: The extension cord must have adequate wire size AWG (AmericanWire Gauge) for safe, efficient use, Smaller gauge wires hav
TOOL USE AND CARE SAFETY1. ALWAYS use clamps or other practical ways to secure and supportthe workpiece to a stable platform. Holding the work by hand
SAFETY RULES FOR SANDERS1. NEVER use this or any power sander for wet sanding or liquidpolishing. Failure to follow this rule will increase the risk o
ADDITIONAL RULES FOR SAFE OPERATION CONT.8. ALWAYS make sure that your extension cord is in good condition.When using an extension cord be sure to use
ADDITIONAL RULES FOR SAFE OPERATION CONT.Z_ WARNING: The operation of any sander canresult in foreign objects being thrown into your eyes,which can re
Before attempting to use any tool, be sure to familiarize yourself withan the operating features and safety instructions.Z_ WARNING: IF ANY PARTS ARE
Commentaires sur ces manuels