Craftsman CompuCarve 133.217540 Instructions d'exploitation télécharger pdf (Page 51)

Chapter 5: Board and View Manipulation

Construction Lines

Construction lines are the horizontal and vertical black dotted center lines that are visible on the surface of the

board. These lines are used to attach geometry and assist in layout. The construction lines can be toggled on and

off by selecting Toggle Construction Lines from the View pull down menu or tool bar.

Figure 5�3� Construction Lines

Rendering Quality

To increase performance, the software normally displays in a lower-quality format while a design is being

manipulated, and then displays in a high quality format after all manipulation has ceased. This function can be

can be toggled on and off by selecting Toggle Auto Re-Render from the View pull down menu or tool bar. The

quality of the rendering can be changed by selecting “Rendering Quality” from the View pull down menu and

clicking on the desired setting from the drop-down button list of rendering quality settings. Faster machines

with good graphics cards may be able to turn off auto-render and run at the highest quality setting.

Grid

A grid of lines can be a useful tool for laying out geometry. The grid can be toggled on or off by

selecting ‘Toggle Grid Lines’ from the ‘View’ menu. The interval of the grid can be changed through

the Snap dialog that is found in the ‘Layout’ menu. (Snap and Grid on page 129)

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 218 219

Pas de commentaire

Craftsman CompuCarve 133.217540 Instructions d'exploitation Page 51