Craftsman 28180 - Fixed-Base Router/Table Combo Manuel télécharger pdf (Page 19)

ADJUSTING THE FENCE

The fence enables you to sup-

port and guide the work piece,.

To adjust the extended fence

forward and backward (Fig, 13)

1. Loosen the two clamping

knobs (5).

2. Move the fence forward or

backward along the slots

to the desired position,

3, Tighten the clamping

knobs.The fence can be

moved forward and back-

ward 3-3/4 in.

To laterally adjust the

infeed and ouffeed fence

The infeed and outfeed fence

can each be adjusted 2 inches

in order to lengthen the fence°

1. Loosen the four wing nut&

2. Move the fence facings

right or left to the desired

position. (Fig° 14)

3. Tighten the wing nuts.

To adjust the outfeed fence

for joining (Fig. 15)

For joining operations, the

outfeed fence can be adjusted

as much as 9/16-inch forward

of the infeed fence to support

the work piece after it passes

across the router bit.

Loosen the two outfeed

fence clamping knobs.

Move the outfeed fence

forward of the infeed fence

to the width of material

you want to remove from

the work piece. Tighten

the clamping knobs.

Fig_ 13

Fig, 'I4

Fig. 15

Move and clamp the entire extended fence so that the outfeed fence is aligned

with the cutting edge of the bit.

28180 ManuaLRevised 07.0228 Page 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Craftsman 28180 - Fixed-Base Router/Table Combo Manuel Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Craftsman 28180 - Fixed-Base Router/Table Combo