Craftsman 315.111371 Manuel de l'opérateur télécharger pdf (Page 10)

TO CHARGE SCREWDRIVER USING CHARGING

STAND

See Figure 4.

• Place screwdriverIn chargingstand maltingsure

InputJackand charger plugare propedyconnected.

• Align slotson screwdriverwithtabs on charging stand

then push on screwdriverto snap into place.

• Connectcharger to power supply.

• A_er normalusage, a minimumof 10 hoursof charg-

Ing time Is requiredto fully charge screwdriver.

• Do not place chargerIn an area ofextreme heat or

cold. It will work best at normalroomtemperature.

SLOTS

CHARGER

COLLET

The coUetonyour screwdriverhas been designedto accept

1/4 In. hex bits.See Figure 6.

TO INSERT BIT

See Figure 6,

Insert bit Into collet asfar as ppsslbTB.

BIT COL_

Fig, 6

LIGHT

See Figure7.

Your screwdriverhas a builtInlight. This feature Is

convenientwhen worldngIndose or tight areas where

additionallight Is needed. A slide switchis Iocatad onthe

bottomof your sorewddver,To turn lightON, push switch

forward,To turn lightOFF, peUback on switch.

Note: Always tum lightoff on our screwdriverwhen not In

use,

CHARGING

STAND Fig. 4

STICK/PISTOL COMBINATION SCREWDRIVER

See Figure 5,

Your screwdriverhas been designed sothat Itcan be

used as a stickscrewdriverora pistolscrewdriver.As

shown In Figure 5, a rotationbuttonis located onthe side

of your screwdriver.To pl,_ceyour screwdriverInpistol

position,holdIt In normaloperatingposition,depress

rotationbuttonand pushdown on handle. To placeyour

screwdriverInstick position,held it In normalopermlng

position,depress rotationbuttonand pullupon handle.

ROTATION

BuTroN

Fig

\ .5

UGHT

LIGHT SWITCH

Fig. 7

1 2 ... 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Craftsman 315.111371 Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Tournevis électriques Craftsman 315.111371