Craftsman 113.198611 Operators Manuel de l'opérateur télécharger pdf (Page 64)

Pull the saw blade through the

workpiece to the distance shown below.

Fig. 147 Distance Needed to Complete Crosscut

12. Support and hold the workpiece down

and against the fence firmly with your left

hand.

13. Pull blade through fence and workpiece

just enough to complete the cut. Fig 147.

14. Return saw to its rearmost position and

continue to hold the saw handle.

15. Turn saw off.

16. Wait for the blade to stop turning.

17. Remove yellow key form red switch.

10. Insert yellow key into red switch.

11. Turn saw on.

l'k

AI_ WARNING: Saw blade can be

pulled into or over fingers or

hand. Fingers or hand can be cut off.

Keep hand holding the workpiece at

least 8 inches to the left of, and out of

the path of the saw blade. Keep hand in

view at all times.

Repetitive Crosscuts

To make repetitive crosscuts:

1. Use two pieces of 1 inch by 2 by 2 inch

lumber.

2. Use a C clamp to clamp one piece on each

side of the lower right edge of the radial arm.

3. Clamp pieces of lumber at the distance

necessary to complete the crosscut.

Fig. 148 Hand Placement for Crosscuts

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 119 120

Pas de commentaire

Craftsman 113.198611 Operators Manuel de l'opérateur Page 64