Craftsman 071-45247 Manuel du propriétaire

Operator’s ManualModel No. 172.452470 16-In. Bar14 Amp/3.5 Peak HP MotorElectric Chain Saw• WARRANTY• SAFETY• UNPACKING• ASSEMBLY• OPERATION• MAINTEN

1918ASSEMBLY & ADJUSTMENTS cont. CAUTION: The chain saw is NOT supplied filled with oil. It is essential to fill with oilbefore use. Never op

2120 WARNING: Check the voltage and electric current supply: The voltageand current supply must comply with the ratings on the data plate.!SWITCHI

2322OPERATION cont.Always hold the chain saw firmly with both hands. Front grip with the left hand and rear gripwith the right hand. Fully grip both h

24 25OPERATION cont.CUTTING LOGSObserve the following safety instructions:Support logs so that the face sides at the cut do not close in against each

26 27OPERATION cont.Limbing is removing the branches froma fallen tree. When limbing leave largerlower limbs to support the log off theground.Remove t

28 29OPERATION cont.When the log is supported on bothends, as illustrated, cut 1/3 thediameter from the top overbuck.Then make the finished cut byunde

3031TROUBLE SHOOTING• Clean the moulded plastic housing of the chain saw using a soft brush and clean cloth. DO NOT use water, solvents or polishes.

3233PARTS LISTThe model number will be found on the nameplate of the Chain Saw.Always mention the model number when requesting parts and service for y

34PARTS LIST35NOTESModel No. 172.452470 16-In. Bar14 Amp/3.5 Peak HP MotorElectric Chain Saw

3SAFETY SYMBOLSWarranty……………………………...……………..Page 2Safety Symbols……………………...

SAFETY INSTRUCTIONS cont.SAFETY INSTRUCTIONS WARNING: If correctly used, this electric Chain Saw is an efficienttool to use; if used improperly o

76SAFETY INSTRUCTIONS cont.SAFETY INSTRUCTIONS cont.Remember, a smaller wire gauge size has greater capacity than a larger number (14-gauge wire has m

SAFETY INSTRUCTIONS cont.9SAFETY INSTRUCTIONS cont.8 WARNING: NEVER reach under the Chain Saw (chain area) until you haveunplugged Chain Saw and

1110SAFETY INSTRUCTIONS cont.SAFETY INSTRUCTIONS cont.ADDITIONAL RULESFOR SAFE OPERATION cont.ADDITIONAL RULESFOR SAFE OPERATION cont. 4. Wear safet

1312SAFETY INSTRUCTIONS cont.ADDITIONAL RULESFOR SAFE OPERATION cont.SAFETY INSTRUCTIONS cont.ADDITIONAL RULESFOR SAFE OPERATION cont. WARNING: W

DESCRIPTION 14KNOW YOUR CHAIN SAWYour Chain Saw has a precision built electric motor and it should only be connected to a 120-volt, 60 Hz AC ONLY powe

1716ASSEMBLY & ADJUSTMENTS The chain saw is intended for wood: sawing of trees, tree trunks, branches, wooden beams,planks, etc. Cuts can be sawed