Craftsman 28934 Manuel de l'opérateur télécharger pdf (Page 25)

REPLACING BATTERY

_sWARNING: Do not short battery

termi-

by allowing a wrench or any other object

to contact both terminals at the same time.

Before connecting battery, remove metal

bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to

prevent sparking from accidental grounding.

1. Lift seat pan to raised position and open

battery box door.

2. Disconnect BLACK battery cable first

then RED battery cable and carefully

remove battery from tractor.

3. Install new battery with terminals in same

position as old battery.

4. First connect RED battery cable to posi-

tive (+) terminal with hex bolt and keps

nut as shown. Tighten securely.

5. Connect BLACK grounding cable to

negative (-) terminal with remaining hex

bolt and keps nut. Tighten securely.

6. Close battery box door.

Seat

Battery

Box Door

Keps

/Nut

Hex

Bolt

Positive

(Red)

Cable

Negative (Black)

Cable

TO REPLACE HEADLIGHT BULB

1. Raise hood.

2. Remove bulb holder from the hole in

the backside of the grill.

3. Replace bulb in holder and install bulb

holder securely back into the hole in

the backside of the grill.

4. Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your

tractor to run poorly, stop running, or prevent

it from starting.

• Check wiring. See electrical wiring dia-

gram in the Repair Parts manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-

in fuse. The fuse holder is located behind

the dash.

TO REMOVE HOOD & GRILL ASSEMBLY

1. Raise hood.

2. Unsnap headlight wire connector.

3. Stand in front of tractor. Grasp hood at

sides, tilttoward engine and tift offoftractor.

4. When replacing hood, be sure to recon-

nect the headlight wire connector.

Headlight

Wire

Connector

ENGINE

TOADJUSTTHROTTLE CONTROLCABLE

The throttle control has been preset at

the factory and adjustment should not be

necessary Check adjustment as described

below before loosening cable. If adjustment

is necessary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the fac-

tory and adjustment should not be necessary.

Ifadjustment is necessary, see engine manual.

TO ADJUST CARBURETOR

Your carburetor has been preset atth e factory

and adjustment should not be necessary.

However, minor adjustment may be required

to compensate for differences in fuel, tem-

perature, altitude or load. If the engine does

need adjustment, see engine manual.

25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Commentaires sur ces manuels

Pas de commentaire