Craftsman 28934 Manuel de l'opérateur télécharger pdf (Page 11)

The operation of any tractor can result in foreign objects thrown into

the eyes, which can result in severe eye damage. Always wear safety

glasses or eye shields while operating your tractor or performing any

adjustments or repairs. We recommend standard safety glasses or a

wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE

Your tractor is equipped with an operator

presence sensing switch. When engine

is running, any attempt by the operator

to leave the seat without first setting the

parking brake will shut off the engine.

1. Depress brake pedal (B) all the way

down and hold.

2. Pull parking brake lever (C) up and

hold, release pressure from brake

pedal (B), then release parking brake

lever. Pedal should remain in brake

position. Make sure parking brake will

hold tractor secure.

STOPPING

MOWER BLADES -

To stop mower blades, move attachment

clutch clutch lever to disengaged position

I) Attachment (t_) Disengaged

Clutch Position

Engage Position

GROUND DRIVE -

* To stop ground drive, depress clutch/

brake pedal all the way down.

* Move motion control lever (J) to neutral

position.

ENGINE -

* Move throttle control (D) between half

and full speed (fast) position.

NOTE: Failure to move throttle control

between half and full speed (fast) posi-

tion, before stopping, may cause engine to

"backfire".

* Turn ignition key (F) to "STOP" position

and remove key. Always remove key

when leaving tractor to prevent unau-

thorized use.

* Never use choke (N) to stop engine.

IMPORTANT: Leaving the ignition switch

in any position other than "STOP" will

cause the battery to discharge and go

dead.

NOTE: Under certain conditions when

tractor is standing idle with the engine

running, hot engine exhaust gases may

cause "browning" of grass. To eliminate

this possibility, always stop engine when

stopping tractor on grass areas.

_IbCAUTION: Always stop tractor

completely, as described above, and set

parking brake before leaving the opera-

tor's position.

TO MOVE FORWARD AND

BACKWARD

The direction and speed of movement

is controlled by the forward and reverse

drive pedals.

1. Start tractor and release parking brake.

2. Slowly depress forward (K) or reverse

(L) drive pedal to begin movement.

Ground speed increases the further

down the pedal is depressed.

TO USE CRUISE CONTROL

The cruise control feature can be used for

forward travel only.

SYSTEM CHARACTERISTICS

The cruise control should only be used

while mowing or transporting on relatively

smooth, straight surfaces. Other condi-

tions such as trimming at stow speeds

may cause the cruise control to disen-

gage. Do not use the cruise control on

slopes, rough terrian or while trimmimg or

turning.

* With forward drive pedal (K) depressed

to desired speed, pull cruise control

lever (J) up and hold while lifting your

foot off the pedal, then release the lever.

To disengage the cruise control, depress

the brake pedal or tap on forward drive

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Commentaires sur ces manuels

Pas de commentaire

Craftsman 28934 Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Craftsman 28934