SHARPENING OR REPLACING CHIPPER
BLADES
• Disconnect the spark plug wire and move away from
the sparkplug.
• Removethe accessplate by removingtwohex lock
nuts. See figure 38.
• Locateone of the chipperblades in the access plate
openingby rotating the impellerassemblyby hand.
Removethe blade usinga 3/16"alien wrench onthe
outsideofthe blade and a 1/2"wrench on the impel-
lerassembly, inside the housing.
• Remove the other blade in the same manner.
• Replace or sharpen blades. If sharpening, make
certain to remove an equal amount from each blade.
Reassemble in reverse order.
NOTE: Make certain the blades are reassembledwith
the sharp edge facing upward, as viewed from the access
plate opening.
FIGURE 38
HEX
LOCK NUTS
• Clean the engine and the entire unit thoroughly.
• Refer to engine manual for correct engine storage
instructions.
• If stohng inan unventilated or metal storage shed,
coat metal parts with light oil or silicone to prevent
rust.
• Store unit in a clean, dry area.
21
Commentaires sur ces manuels