Craftsman 486.24515 Manuel du propriétaire télécharger pdf (Page 19)

USING THE CHIPPER CHUTE

• Materialsuchas stalksor heavybranchesup to 3" in

diameter may be fed intothe chipperchute as shown

in figure 37.

• Be sure to wear eye protection and gloves when

feeding material into the chipper chute.

• Use the tamper plug, not your hands, to force material

down through the chipper chute.

For best performance, it is important to keep the

chipper blades sharp. If the compositionof the

material being discharged changes (becomes stnngy,

etc.) or if the rate of discharge slows down consider-

ably, it is likelythat the chipper blades are dull and

need to be sharpened or replaced. Refer to the

Service and Adjustments section, on page 21.

WARNING: Do not attempt to feed an_i

material larger than 3" in diameter into

the chipper chute. Personal injury or

damage to the machine could result.

DANGER: Keep hands out of chipper

chute. Rotating blades in impeller

housing can cause serious injury. Use

the tamper plugto help push material

clowninto the chute.

FIGURE 37

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Craftsman 486.24515 Manuel du propriétaire Page 19