Craftsman CompuCarve 133.217540 Manuel de l'opérateur télécharger pdf (Page 31)

Sears, Roebuck and Co. CompuCarve™ System (Rev 1.18) 04/23/07

Proper Bit Installation Into the Bit Adapter

1/2" Adapter Style – Assemble the bit so that the face of the adapter is 1/8” from the bottom of the cutting surface.

A B C

(Correct) (Incorrect) (Incorrect)

1/4" Adapter Style –

Like the 1/2" style, assemble the bit so that the face of the adapter is 1/8” from the bottom of

the cutting surface. The only exception to this is the 1/4" Ball Nose bit (BBN25) and solid carbide bits. This BBN25 bit

must be assembled as shown in Figure 25.

FIGURE 24: CORRECT BIT ASSEMBLY IS SHOWN IN EXAMPLE A. THE BIT

TOO LOW IN EXAMPLE B AND TWO HIGH IN EXAMPLE C.

IGURE 25: CORRECT BIT ASSEMBLY

POSITION FOR ¼” BALL NOSE BIT

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 45 46

Pas de commentaire

Craftsman CompuCarve 133.217540 Manuel de l'opérateur Page 31