Craftsman YS 4500 917.28990 Manuel d'utilisateur télécharger pdf (Page 28)

REPLACING BATTERY

^WARNING: Do not short battery

terminals by allowing a wrench or any

other object to contact both terminals at

the same time. Before connecting battery,

remove metal bracelets, wristwatch bands,

rings, etc.

Positive terminal must be connected

first to prevent sparking from accidental

grounding.

1. Lift hood to raised position.

2. Disconnect BLACK battery cable (A)

then RED battery cable and carefully

remove battery from tractor.

TO REMOVE HOOD AND GRILL AS

SEMBLY

3.

4.

5.

6.

TO REPLACE HEADLIGHT BULB

4.

Raise hood.

Remove bulb holder from the hole in

the backside of the grill.

Replace bulb in holder and install bulb

holder securely back into the hole in

the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause

your tractor to run poorly, stop running,

prevent it from starting.

• Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type

plug-in fuse. The fuse holder is located

behind the dash.

or

4.

Raise hood.

Unsnap headlight wire connector.

Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of

tractor.

When replacing hood, be sure to re

connect the headlight wire connector.

Install new battery with terminals in

same position as old battery.

First connect RED battery cable (B) to

positive (•+) battery terminal with hex bolt

and keps ñutas shown. Tighten securely.

Slide terminal cover (C) over terminal.

Connect BLACKgrounding cable to nega

tive (-) battery terminal with remaining

hex bolt and keps nut. Tighten securely.

Close hood.

ENGINE

Maintenance, repair, or replacement of

the emission control devices and systems,

which are being done at the customers ex

pense, may be performed by any non-road

engine repair establishment or individual.

Warranty repairs must be performed by an

authorized engine manufacturer's service

outlet.

CARBURETOR

If your engine does not operate properly

due to suspected carburetor problems,

take your tractor to a Sears or other

qualified service center for repair and/or

adjustment.

High speed stop is factory adjusted. Do

not adjust - damage may result.

IMPORTANT: Never tamper with the

engine governor, which is factory set

for proper engine speed. Overspeed

ing the engine above the factory high

speed setting can be dangerous. If you

think the engine-governed high speed

needs adjusting, contact a Sears or other

qualified service center,, which has proper

equipment and experience to make any

necessary adjustments.

28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

Commentaires sur ces manuels

Pas de commentaire