Craftsman CR-KYPD Manuel du propriétaire télécharger pdf (Page 15)

To Connect the Push Button to the Opener

Connect the pair of wires from the push button to the pair of

“PUSH BUTTON” terminals on the rear of the opener. Refer to

Wiring Instructions on page 13 to ensure wires are properly

connected.

The push button is a wired, illuminated door control placed

inside your garage.

To install the Push Button:

1. Inside your garage, install push button within sight of the

door at a minimum height of 5 feet (1.5m) off the ground.

Ensure it is installed out of the reach of children and free

from the moving parts of the door and hardware.

2. Securely fasten it to a solid surface with 1” screws. If

attaching to drywall or other hollow surface, drill 3/16”

holes and use the provided drywall anchors.

To prevent SERIOUS INJURY or DEATH from electrocution:

- Power MUST NOT be connected until instructed.

To prevent SERIOUS INJURY or DEATH from using the push button and a closing door:

- Install the push button within sight of the door at a minimum height of 5 feet (1.5m) above the floor.

Make sure it is out of the reach of children and moving parts of door and hardware.

- NEVER permit children to access the push button or remote controls.

- Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.

- ALWAYS keep a moving door in sight until it’s completely closed.

- NEVER cross the path of a moving door.

Push Button

Min. 5 feet (1.5m)

above floor

From Push Button

Connecting Push Button

WARNING

Drywall Anchor

Screw #6 x1-1/4

NOTICE: Only use the Push Button included with this GDO model or identical replacement part. See

Accessories in Repair Parts section of this manual.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Pas de commentaire

Craftsman CR-KYPD Manuel du propriétaire Page 15