• Assemble a hitch arm to the inside of a frame tube
underneath the tank. Use two 5/16" x 2" hex bolts (A)
and 5/16" nylock nuts (F).
• Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts (B) and 5/16" nylock nuts (F).
• Assemble the hitch brackets to the hitch arms using
two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts
(F). Position each bolt behind a cross bolt in the hitch
all nuts assembled in steps 3 and 4 at this
• Assemble the boom mount bracket to the rear of the
frame tubes using two 5/16" x 2" hex bolts (A) and
5/16" x 2"
HEX BOLT (A)
5/16" NYLOCK
NUT (F)
HITCH ARM
5/16" x 2"
HEX BOLT (A)
5/16" NYLOCK
NUT (F)
5/16" x 1-1/4"
HEX BOLT (B)
5/16" NYLOCK
NUT (F)
5/16" NYLOCK NUT (F)
5/16" x 2"
HEX BOLT (A)
STEP 2: (SEE FIGURE 2 AND 1)
• Slide the axle through the two axle brackets.
• Assemble a spacer (R), a 3/4" washer (H), a wheel
(valve stem facing out) and another 3/4" washer (H)
onto the axle. Assemble a cotter pin (M) through the
end of the axle. Re peat on other end.
the four nuts which fasten the axle clamps to
the frame tubes. Refer back to fi gure 1.
3/4" WASHER (H)
SPACER (R)
1/8" x 1-1/2"
COTTER PIN (M)
Commentaires sur ces manuels