Craftsman 139.53647SRT1 Manuel du propriétaire Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
Assembly Step 2
Install the Trolley on the T-rail
Place the opener on packing material to protect
the cover. For convenience, put a support under
the cable pulley bracket.
Remove the (2) 5/16"-18x1/2" washered screws
mounted in the top of the opener.
Align the holes in the back section of the T-rail with
the holes in the opener.
Fasten the rail with the (2) washered screws
previously removed. Tighten securely.
Remember to use only these screws! Any other
screws will cause serious damage to the opener.
Insert a 5/16"-18x7/8" hex screw into the cover
protection bolt hole in the T-rail as shown. Tighten
securely with a 5/16" lock washer and nut.
NOTE: This screw prevents trolley over-travel.
Keep a 2" minimum between the trolley and this
screw when adjusting travel limits (see page 28).
Use Only This
Type and Size
Screw
Washered Screw
5/16"-18x1/2"
T-rail
(Back Section)
Cover
Protection
Bolt Hole
Nut
5/16"-18
Hex Screw
5/16"-18x7/8"
Lock Washer
5/16"
9
Attach the threaded shaft to the trolley with the
lock washer and nuts as shown.
As a temporary stop, insert a screwdriver into the
hole in the front end of the T-rail.
Slide the trolley assembly along the rail to the
screwdriver stop.
If trolley hits against any nuts on the T-rail, the
bolts and nuts were attached from the wrong
side and must be repositioned. Review Step 1.
Temporary Stop
Screwdriver
Trolley
TO GARAGE DOOR
Trolley
Threaded Shaft
Lock Washer
5/16"
Outer Nut
5/16"
Inner Nut
5/16"
Trolley
Assembly Step 3
Fasten the T-rail to the Opener
To fasten rail, use only those screws mounted
in the top of the opener. Any other screws will
cause serious damage to the opener.
Lock Washer
5/16"
Nut
5/16"-18
Hardware Shown
Actual Size
Nut
5/16"
Lock Washer
5/16"
Hex Screw
5/16"-18x7/8"
Hardware Shown Actual Size
WARNING
CAUTION
CAUTION
WARNING
WARNING
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Commentaires sur ces manuels

Pas de commentaire