Craftsman 113.221740 Spécifications télécharger pdf (Page 30)

Basic Saw Operations (continued) ............................

Using Featherboards for Thru-Sawing

Featherboards are not employed for thru-sawing opera-

tions when using the miter gauge,

Featherboards are used to keep the work in contact with

the fence and table as shown, and to he!p stop kickbacks_

Add a 7-1/2" high flat facing board to the full length of the

fencer

Mount featherboards to fence and table as shown.

WARNING: Make sure the featherboard against the

edge presses only on the uncut portion (in front of

the blade). It might otherwise pinch the blade in the

kerf and cause a kickback.

Before starting the operation (turn switch "OFF" and

lower blade or cutter below table surface):

• install featherboards so they exert pressure on the

workpiece; be positive they are securely attached.

. Make sure by trial that the featherboards will stop a

kickback if one should occur' before performing this

operation,.

Before starting your cut:

• Slide the workpiece in between the featherboards the

same way you'll feed it in for the cut°

• Pull back on the workpiece. The piece should be

harder to pull back than it was to push forward.

o Adjust your featherboards and repeat the trial, as

needed.

o Fellow the applicable dpping instructions to make the

cut

Resawing

Resawing is a thru-sawing cut made by ripping a piece of

wood through its thickness.

WARNING: Do not attempt to resaw bowed or

warped material, it can't be properly supported. It

could kickback or bind.

NOTE: To resaw a piece of wood wider than 3", it will be

necessary to remove the blade guard and use the auxit-

"i'ary fence/work support_ (See "Workfeed Devices" on

page 21-22)°

Clarnp the auxiliary fence/work support to the table so

that the workpiece wilt slide easily without binding

between the two fences and it will not tilt or' move side-

ways,

Do not clamp directly to the bottom edge of the table

because the "swivel" of the clamp will not grip properly_

Place a small block of wood between the bottom edge of

the table andthe "G" clamp.

WARNING: For your own safety ,

1. Do not "Backup" (reverse feeding) while resaw-

ing because this could cause a kickback.

2. Make first pass to a depth slightly more than one

half the width of the board; keep same face of

board against fence for second pass,

WARNING: For your own safety, install blade guard

immediately upon completion of the resawing oper-

Work Supports

"C" Clamps

Auxiliary Fence_

Small Blockof Wood

Featherboard

Front of Saw

"=erboard

Push Stick

}iece

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Craftsman 113.221740 Spécifications Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour écrans plats Craftsman 113.221740