Instruction ManualI CRAFTSMAN°I25cc/1.5 cu.in. 2-Cycle205 MPH/410 CFMGASOLINE POWEREDBLOWER/VACModel No.358.797341• Safetyi ssem ,,OperationMaintenanc
REPLACE SPARK PLUGReplace spark plug each year to ensurethe engine starts easier and runs better.Set spark plug gap at 0.025 inch. Igni-tion timing is
ADJUSTING PROCEDURECAUTION: Do not force plastic limitercaps on screws beyond the built-instops or damage will occur.Initial Settings1. Turn both mixt
TROUBLESHOOTING TABLEWARNING: Always stop unit and disconnect spark plug before perform-ing any of the recommended remedies below other than remedies
MANUFACTURER'S WARRANTYCOVERAGE: If any emissions relatedpart on your engine (as listed underEmissions Control Warranty Parts List)is defective o
Warranty Statement 2 Storage 11Safety Rules 2 Troubleshooting Table 12Assembly 4 Emissions Statement 12Operation 6 Parts List 14Maintenance 9 Spanish
• Do not operate unit when you aretired, ill, upset, or if you are under theinfluence of alcohol, drugs, or medica-tion.• Keep children, bystanders, a
• Empty fuel tank before storing the unit.Use up fuel left in carburetor by start-ing engine and letting it run until itstops.• Do not use any accesso
VACUUM ASSEMBLYVACUUM BAG ASSEMBLY1. Open tile zipper on the vacuumbag and insert the elbow tube.2. Push the small end of the elbowtube through the sm
SHOULDER STRAP ADJUSTMENT(for vacuum use only)1. Hold the unit as shown.2. Pass the shoulder strap over yourhead and onto your right shoulder.3. Exten
OPERATING TIPS• While vacuuming or blowing debris,hold the unit with the muffler side fac-ing away from your body and clothes(see OPERATING POSITION).
STARTING THE ENGINE_,WARNING: You MUST make surethe tubes are secure before using theunit.• Fuel engine. Move at least 10 feet (3meters) away from the
CUSTOMER RESPONSIBILITIESCARE & MAINTENANCE TASKCheck for loose fasteners and partsCheck for damaged or worn partsInspect and clean unit and label
Commentaires sur ces manuels